Pilot V6-3.5L (2004)
5. Install the steel balls (A) and the bearing retainer (B) onto the bearing race (C) by aligning the marks (D) on the bearing retainer and the bearing
race.
6. Install the bearing onto the driveshaft (E) by aligning the marks (D) on the bearing and the driveshaft.
7. Install the snap ring (F).
8. Pack the inboard joint with the joint grease included in the new driveshaft set.
Grease quantity
Inboard joint:
Left driveshaft: 160 - 180 g (5.6 - 6.4 oz)
Right driveshaft: 190 - 210 g (6.7 - 7.4 oz)
9. Fit the inboard joint onto the driveshaft, and note these items:
^
Reinstall the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and the rollers.
^
Hold the driveshaft so the inboard joint points up to prevent it from falling off.