Pilot V6-3.5L (2004)
20. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything, and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
21. Repeat steps 16 through 22 for the band on the other end of the boot.
22. Install a new locking tab type boot band on the inboard joint side of the inboard boot. Fold down the locking tabs.
23. Lightly tap on the double-over portions to reduce their height.
24. Install a new set ring (left driveshaft).
Outboard Joint Side: