Pilot V6-3.5L (2004)
11. Check the clearance between the closed ear portion of the band. If the clearance is not within the standard, close the ear portion of the band farther.
12. Repeat steps 10 and 11 for the band on the other end of the boot.
Front Driveshafts Installation
Front Driveshafts Installation
1. Install a new set ring in the set ring groove of the driveshaft (left driveshaft).
2. Apply 2.0 - 3.0 g (0.07 - 0.10 oz) of grease to the whole splined surface (A) of the right driveshaft. After applying grease, remove the grease from
the splined grooves at intervals of 2 - 3 splines and from the set ring groove (B) so that air can bleed from the intermediate shaft.
