Pilot 2WD V6-3.5L (2006)
Rear Door Weatherstrip: Service and Repair
Rear Door Weatherstrip
Rear Door Weatherstrip Replacement
NOTE:
-
Take care not to scratch the door.
-
Use a clip remover to remove the clips.
1. At the B-pillar, remove the door checker mounting bolt (A).
2. Detach the clips (B, C), then remove the door weatherstrip (D).
3. Install the weatherstrip in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Push the clips into place securely.
-
Make sure the weatherstrip is installed in the holder (E) securely.
-
Apply liquid thread lock to the door checker mounting bolt before installation.
-
Check for water leaks.
-
Test-drive and check for wind noise and rattles.