Pilot 2WD V6-3.5L (2006)
Trim Panel: Service and Repair
Trim Removal/Installation - Door Areas
Trim Removal/Installation - Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Pull out the fuel fill door opener knob (A), and detach the tabs (B) from the kick panel (C) and B-pillar lower trim (D), and pull the front door sill
trim (E) up by hand to detach the clips (F) and a clip (G) (driver's), then remove it.
2. Pull the front side outer trim (H) by hand to detach the clips, then remove it.
3. Remove the kick panel (A).
1. Pull out the door opening trim (B) as needed from the kick panel hook (C) and the door opening flange.
2. Release the clip (D).
3. Pull the kick panel back by hand to detach the clip (E), then remove it.