Pilot 2WD V6-3.5L (2006)
Use alcohol, a tack cloth, and wax and grease remover.
Also, clean and degrease the surfaces where the masking tape will be attached.
Top Coating
Top Coating
1. Masking
Mask the area surrounding the damage to prevent over-spray of the top coat.
Use masking tape and paper.
2. Spraying top coat enamel / clear coat
Spray 2~3 double coats until the intermediate coat is fully covered.
NOTE:
-
Do not cover the surface with one heavy coat.
-
Apply several thin coats.
-
Use a 2-part polyester urethane top coat enamel and a spray gun.
-
Mix the top coat enamel with the additive and solvent, using the correct ratio.
-
Follow the top coat manufacturer's instructions.
After spraying the top coat enamel, allow for 5-10 minutes drying time before you spray the clear coat.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
After spraying the clear coat, allow for 5-10 minutes drying time before you force dry it with infrared lamps or an industrial dryer.
3. Polishing / buffing
-
Check that the clear coat has dried thoroughly.
-
Wet sand to remove any imperfections.
Use a flexible block, soap, and #2000 sandpaper.
-
Using a buffer and compound, remove any polishing marks made from the sandpaper.
Use a buffing sponge, and buffing wool and compounds.
Finish by buffing:
-1. Wet sand with #2000 sandpaper and soapy water.