Pilot 2WD V6-3.5L (2006)
4. Spraying primer surfacer
-
Spray about 4 to 5 coats to get 20 microns of thickness. One coat deposits about 5 to 7 microns.
-
Do not try to cover the surface with one heavy coat. Applying several thin coats is recommended.
-
Use a 2-part urethane primer surfacer and a spray gun.
-
Mix the primer surfacer with the additive and solvent, and in the correct ratio.
-
Follow the primer surfacer manufacturer's instructions.
5. Drying
After spraying primer surfacer, allow 7 to 10 minutes of drying time, then forces dry it with infrared lamps or an industrial dryer.
6. Polishing
Check that the primer surfacer has dried thoroughly, then sand the primer surfacer.
Use a double action sander and #400~#600 disc sandpaper.
7. Intermediate coating and top coating
Refer painting procedure.