Pilot 2WD V6-3.5L (2006)
Seat Latch Cable: Service and Repair
Second Row Seat-Back Recline Cable
Second Row Seat-back Recline Cable Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
*
Available through the American Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend the cable.
1. Remove the seat-back recline lever.
2. Carefully pry out the cover (A) with a flat-tip screwdriver at the gap while holding the lever fully open. Release the tabs (B) and the stops (C), then
remove the cover.
3. Disconnect the recline cables (A). There is no inner recline cable on the right recline lever.
4. Install the second row seat-back recline cables in the reverse order of removal, and make sure the cables are connected securely.