Pilot 2WD V6-3.5L (2006)
6. Inspect all connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 7.
7. With the driver's multiplex control unit still disconnected, make these input tests at the driver's under-dash fuse/relay box socket.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step B.
8. With the driver's multiplex control unit still disconnected, make these input tests at the driver's under-dash fusel relay box socket.
9. Remove the passenger's multiplex control unit from the passenger's under-dash fuse/relay box and connect fusel relay box socket terminal A12 to
battery voltage. This4urns the power window relay on.
-
If any test indicates a problem, find and correct the cause, then recheck the system
-
If all the input tests prove OK, go to step 10.
Door Unit
10. Remove the door multiplex control unit from the driver's door, and disconnect its connectors.