Pilot 4WD V6-3.5L (2008)
![background image](/honda/pilot_4wd/v6-3.5l/Page-2202001.png)
Rear Bumper: Service and Repair
Rear Bumper Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
NOTE:
-
Have an assistant help you when removing and installing the rear bumper.
-
Take care not to scratch the rear bumper and body.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Put on gloves to protect your hands.
1. Remove the rear bumper as shown.
2. Install the bumper in the reverse order of removal, and note these items:
-
Make sure the rear bumper engages the hooks of the side spacers and upper brackets on both sides securely.
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Push the clips and hooks into place securely.