Pilot 4WD V6-3.5L (2008)
-
Push lightly on the upper clip. If you push too hard, the clip will be damaged, and it will not hold the trim properly.
13. Install the B-pillar lower trim (A) in the reverse order of removal, and note these items:
-
Check if the clips (B) are damaged or stress-whitened, and if necessary, replace them with new ones.
-
To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they
are damaged:
-
Any cracks, deformations, or stress-whitening area in the B-pillar lower trim
-
Any cracks, or stress-whitenings in the clip seating surfaces (C)
-
Push the clips into place securely.
14. Install the trim in the reverse order of removal, and note these items:
-
Apply liquid thread lock to the front seat belt upper anchor bolt before installation.
-
Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
C-Pillar Trim
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to scratch the trim and panels.
-
The upper clip in the C-pillar trim (A) consists of a grommet (B) and a pin (C). The grommet expanded with the pin secures it to the body panel
(D); The projections (E) on the pin is broken during removal, so the clip must be replaced with a new one when the trim is reinstalled.
1. Remove these items:
