Pilot 4WD V6-3.5L (2008)
5. Spraying primer surfacer
NOTE: Spray the bumper primer on the area where the PP material was exposed and around the putty.
-
Spray the primer surface wider than the putty and painted surfaces of bumper primer.
-
Spray 2 to 3 coats to get 20 to 30 microns of thickness.
-
Use the 2-component type primer surfacer (gray) and a spray gun.
-
Follow the materials manufacturer's instructions.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
6. Sanding
After drying, wet sand the area of the intermediate coat.
Use #600 sandpaper.
NOTE: Do not use less than #600 sandpaper.
7. Air blowing/degreasing
Use alcohol, a tack cloth, and wax and grease remover.
Also, clean and degrease the surfaces where the masking tape will be attached.
Intermediate Coating
Intermediate Coating
NOTE: You must do this procedure on the PP parts of the bumper and side sill panel.
1. Masking
Mask the area surrounding the damage to prevent over-spray from the intermediate coat.
Use masking tape and paper.