Pilot 4WD V6-3.5L (2008)
![background image](/honda/pilot_4wd/v6-3.5l/Page-601001.png)
Connecting Rod: Specifications
Connecting Rod
Pin-to-piston clearance
Standard or New .......................................................................................................................................... 0.005 - 0.014 mm (0.0002 - 0.0006 inch)
Service Limit ......................................................................................................................................................................... 0.019 mm (0.0007 inch)
Small-end bore diameter
Standard or New ...................................................................................................................................... 21.970 - 21.976 mm (0.8650 - 0.8652 inch)
Large-end bore diameter
Standard or New .......................................................................................................................................................................... 58.0 mm (2.28 inch)
End play installed on crankshaft
Standard or New .................................................................................................................................................. 0.15 - 0.35 mm (0.006 - 0.014 inch)
Service Limit ............................................................................................................................................................................. 0.45 mm (0.018 inch)
Line up the mark (A) on the connecting rod and cap, then install the cap.
Apply new engine oil to the bolt threads and flanges. Torque the bolts (B) to 20 Nm (2.0 kgf-m, 14 ft. lbs.).
Mark the connecting rod (A) and bolt head (B) as shown.
Tighten the bolt until the mark on the bolt head lines up with the mark on the connecting rod (turn the bolt 90°).