Pilot 4WD V6-3.5L (2008)
39. Install the oil filter base/oil filter assembly (A), with a new O-ring (B) (J35Z1 engine).
40. Install the oil pan.
41. Install the crankshaft position (CKP) sensor.
42. Install the cylinder heads:
^
J35A9 engine
^
J35Z1 engine
43. Install the drive plate.
44. Install the transmission.
45. Install the engine assembly.
NOTE: When any crankshaft or connecting rod bearing is replaced, after assembly it is necessary to run the engine at idling speed until it reaches
normal operating temperature, then continue to run it for about 15 minutes.