Pilot 4WD V6-3.5L (2008)
Intake Manifold: Service and Repair
Injector Base Removal and Installation
Injector Base Removal and Installation
Removal
1. Relieve the fuel pressure.
2. Remove the power steering (P/S) pump and P/S hose bracket.
3. Remove the intake manifold.
4. Remove the injectors.
5. Remove the harness bracket mount bolt (A) and the knock sensor connector (B).
6. Remove the injector base mount bolts/nuts (A), then remove the front injector base (B) and rear injector base (C).
Installation
1. Install the front injector base (A) and rear injector base (B) with new gaskets (C), and torque the bolts/nuts (D) in a crisscross pattern in three
steps, beginning with the inner nuts.
NOTE: The front injector base gasket is different from the rear one. Do not mix injector base gasket types.