Pilot 4WD V6-3.5L (2008)
Seats with Side Airbags
Seats with side airbags have a "SIDE AIRBAG" tab on the seat-back. Because the component parts (seat-back cover, cushion, etc.) of seats with and
without airbags are different, make sure you install only the correct replacement parts.
-
When cleaning, use a damp cloth to clean the seat. Do not soak the seat with liquid, and do not spray steam on the seat.
-
Do not repair a torn or frayed seat-back cover. Replace the seat-back cover.
-
After a collision where the side airbag was deployed, replace the side airbag with new parts. If the seat-back cushion is split, it must be replaced. If
the seat-back frame is deformed, it must be replaced.
-
Never put aftermarket accessories on the seat (covers, pads, seat heaters, lights, etc.).
Disconnecting System Connectors
Turn the ignition switch OFF, disconnect the negative cable from the battery, and wait at least 3 minutes before beginning the following procedures.
-
Before disconnecting the cable reel 4P connector (1), disconnect the driver's airbag 4P connector 2.
-
Before disconnecting SRS unit connector B from the SRS unit, disconnect both seat belt tensioner 2P connectors (3,4).