Pilot 4WD V6-3.5L (2008)
2. Remove the driver's airbag from the steering wheel by removing the access panel from the steering wheel, then disconnecting the driver's airbag 4P
connector from the cable reel.
3. Using a TORX T30 bit, remove the two TORX bolts.
4. Disconnect the horn switch connector, radio remote switch connector, and the cruise control set/decel, resume/accel, cancel switch connector.
5. Remove the steering wheel nut.
6. Remove the steering wheel. Use a steering wheel puller, if needed.
NOTE:
^
Do not tap on the steering wheel or steering column when removing the steering wheel.