Pilot 4WD V6-3.5L (2008)
To release the lock, pull the spring-loaded sleeve (A) and the slider (B) while holding the opposite half of the connector. Then pull the connector halves
apart. Be sure to pull on the sleeve and not on the connector half.
Connecting
Hold both connector halves, and press them firmly together until the projection (A) of the sleeve-side connector clicks.
Opening the SRS Unit Shorting Connectors For Diagnosis
Special Tools Required
SRS short canceller 070AZ-SAA0100
NOTE:
-
To prevent damaging the connector cavity, insert the SRS short canceller (070AZ-SAA0100) straight into the cavity from the terminal side.
-
Before installing the short canceller, wash it with electrical contact cleaner, then dry it with compressed air.
-
Do not use the short canceller if it is damaged.
-
Make sure to remove the short canceller before reconnecting.
When SRS unit connector A or C is disconnected, a short circuit is created in the connector by its own function to prevent airbag deployment. The circuit
may need to be opened when diagnosis is performed on the circuit.
Insert the short canceller (T/N 070AZ-SAA0100) in the specified cavities when it is necessary to keep the circuit open for diagnosis.