Pilot 4WD V6-3.5L (2008)
4. Turn the ignition switch OFF.
5. Remove the fuel fill cap.
6. Disconnect the negative cable from the battery.
7. Remove the quick-connect fitting cover (A).
8. Check the fuel quick-connect fitting for dirt, and clean it if needed.
9. Place a rag or shop towel over the quick-connect fitting (A).
10. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the retainer tabs (C) with the other hand to release
them from the locking tabs (D). Pull the connector off.
NOTE:
-
Be careful not to damage the line (E) or other parts.
-
Do not use tools.
-
If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
-
Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
11. After disconnecting the quick-connect fitting, check it for dirt or damage.
12. Reconnect the negative cable to the battery, then do this:
-
Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets.
-
Set the clock (on vehicles without navigation).