Pilot 4WD V6-3.5L (2008)
19. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
20. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the attachment, the support base, and a press. Be
careful not to damage the sleeve of the pack seal.
21. Install the snap ring (A) securely in the knuckle (B).
22. Install the splash guard (C), and tighten the screws (D) to the specified torque value.
23. Install the hub (A) onto the knuckle (B) using the attachment, the driver, the support base, and a hydraulic press. Be careful not to deform the
splash guard (C).