Pilot 4WD V6-3.5L (2008)
Information Bus: Testing and Inspection
Gauge Control Module Input Test
Gauge Control Module Input Test
NOTE: If there is malfunction of the parking brake reminder and speedometer function simultaneously, troubleshooting the vehicle speed signal circuit
first.
1. Remove the gauge control module and disconnect 36P connector B from the gauge control module.
2. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 3.
3. Reconnect the connectors to the gauge control module, and make these input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the gauge internal circuit must be faulty; replace the gauge control module.
