honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

BRN Wire Communication Line Test|Page 3215 > < BRN Wire Communication Line Test|Page 3213
Page 6
background image

Is there continuity?

YES - Repair short to body ground in the wire(s) between the climate control unit and the navigation unit.

NO - Check for loose wire or poor connections at climate control unit connector A (20P) and at the navigation unit connector A (20P). If the
connections are good, substitute a known-good climate control unit and/or navigation unit, and recheck. If the symptom/indication goes away,
replace the original climate control unit and/or navigation unit.

PNK Wire Communication Line Test

PNK Wire Communication Line Test

1. Disconnect driver's multiplex control unit connector B (22P).
2. Disconnect passenger's multiplex control unit connector B (22P).
3. Check for continuity between the B1 terminal of the driver's multiplex control unit connector B (22P) and the B9 terminal of the passenger's

multiplex control unit connector B (22P).

Is there continuity?

YES - Replace the multiplex control unit most closely related to the failure.

NO - Repair an open in the wire between the driver's multiplex control unit connector B (22P) and passenger's multiplex control unit connector B
(22P).

Shorted Communication Line Test

Shorted Communication Line Test

1. Remove the driver's multiplex control unit from the driver's under-dash fuse/relay box.
2. Carefully pry off the driver's door switch trim.
3. Disconnect door multiplex control unit connector A (20P).
4. Disconnect passenger's multiplex control unit connector B (22P).
5. Check for continuity between the No.15 terminal of door multiplex control unit connector A (20P) and body ground.

BRN Wire Communication Line Test|Page 3215 > < BRN Wire Communication Line Test|Page 3213