Pilot 4WD V6-3.5L (2008)
3. Turn the ignition switch ON (II). If the driver's seat belt is unbuckled, the seat belt reminder will beep five times.
4. After about 5 seconds, the ignition key light should come on and the beeper should beep for 2 seconds, go off for 0.2 seconds, then blink and beep
for 0.2 second. This means that you are in Mode 1 of the self-diagnosis function. Check self-diagnostic function Mode 1 for a diagnostic trouble
code (DTC).
Did the multiplex system enter Mode 1?
YES - Go to step 5.
NO - Go to step 6.
5. Check for a DTC.
-
If there are no DTCs present:
The ignition key light and beeper will not blink/beep again after the Mode 1 indication.
-
If there is a DTC present:
About 1 second after entering Mode 1, the ignition key light and beeper indicate the DTC(s), then repeat it every 3 seconds. If there is more
than one DTC, the system will indicate them in succeeding order.
Is there a DTC present?
YES - Follow the procedure in the chart.
NO - Go to Mode 2.