Pilot 4WD V6-3.5L (2008)
Fuel Tank Unit: Service and Repair
Fuel Tank Unit Removal/Installation
Fuel Tank Unit Removal/Installation
Special Tools Required
Fuel sender wrench 07AAA-S0XA100
REMOVAL
1. Relieve fuel pressure.
2. Remove the fuel fill cap.
3. Remove the driver's side second row seat.
4. Cut the carpet at the dotted line (A). Be careful not to cut the wire harness under the carpet.
5. Remove the access panel (A) from the floor, then disconnect the fuel tank unit 5P connector (B).
6. Disconnect the quick-connect fitting (C) from the fuel tank unit.
7. Using the special tool, loosen the fuel tank unit locknut (A).
8. Remove the locknut (A) and the fuel tank unit (B).