Pilot 4WD V6-3.5L (2008)
Engine Control Module: Testing and Inspection
How to Troubleshoot Circuits At the PCM
How to Troubleshoot Circuits at the PCM Connectors
NOTE: The PCM overwrites data and monitors the EVAP system for up to 15 minutes after the ignition switch is turned OFF. Jumping the SCS line
after turning the ignition switch OFF cancels this function. Disconnecting the PCM during this function, without jumping the SCS line first, can damage
the PCM.
1. Jump the SCS line with the HDS.
2. Remove the cover (D) from the PCM.
3. Disconnect PCM connectors A, B, and C.
NOTE: PCM connectors A, B, and C have a symbols (A=D, B=A, C=O) embossed on them for identification.
4. When diagnosis/troubleshooting is done at a PCM connector, use the measurement test port (A) above the terminal you need to check.
5. Connect one side of the patch cord (A) terminals to a commercially available digital multimeter (B), and connect the other side of the patch cord
terminals to a commercially available banana jack (Pomona Electronics Tool No. 3563 or equivalent) (C).
6. Gently slide the pin probe (male) at the terminal test port from the terminal side. Do not force the tips into the terminals.
NOTICE
-
For accurate results, always use the pin probe (male).