Pilot 4WD V6-3.5L (2008)
Is there continuity?
YES - Go to step 6.
NO - Repair open in the wire between each ignition coil 3P connector terminal No. 2 and body ground.
6. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC). Turn the ignition switch ON (II), and jump the SCS line with the
HDS, then turn the ignition switch OFF.
NOTE: This step must be done to protect the powertrain control module (PCM) from damage.
7. Disconnect PCM connector A (44P).
8. Check for continuity between ignition coil relay 4P socket terminal No. 3 and body ground.
Is there continuity?
YES - Repair short in the wire between ignition coil relay 4P socket terminal No. 3 and the PCM (A6).
NO - Go to step 9.
9. Check for continuity between ignition coil relay 4P socket terminal No. 3 and PCM connector terminal A6.
Is there continuity?
YES - The system is OK at this time. Check for loose or poor connections at the ignition coil relay and the PCM(A6).
NO - Repair open in the wire between ignition coil relay 4P socket terminal No. 3 and the PCM (A6).