Pilot 4WD V6-3.5L (2008)
Control Module: Programming and Relearning
Substituting the PCM
Substituting the PCM
Special Tools Required
^
Honda diagnostic system (HDS) tablet tester
^
Honda interface module (HIM) and an iN workstation with HDS and CM update software
^
HDS pocket tester
^
GNA600 and an iN workstation with HDS and CM update software
NOTE: Use this procedure when you have to substitute a known-good PCM during troubleshooting procedures.
1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the PCM. If it do not, go to the DLC circuit troubleshooting. If you are returning from the DLC circuit
troubleshooting, skip steps 4 to 9, and clean the throttle body after substituting the PCM.
4. Select the INSPECTION MENU with the HDS.
5. Select the ETCS TEST, then select the TP POSITION CHECK, and follow the screen prompts with the HDS.
NOTE: If the TP POSITION CHECK indicates FAILED, continue this procedure.
6. Turn the ignition switch OFF.
7. Jump the SCS line with the HDS.
8. Remove the cover (D).
9. Disconnect PCM connectors A, B, and C.
NOTE: PCM connectors A, B, and C have symbols (A=[square], B=[triangle], C=[circle]) embossed on them for identification.