Pilot 4WD V6-3.5L (2008)
Air Bag(s) Arming and Disarming: Service and Repair
Precautions and Procedures
General Precautions
Please read the following precautions carefully before performing airbag system service. If the instructions described are not properly followed, the
airbags could accidentally deploy and cause damage or injuries.
-
Except when performing electrical inspections, always turn the ignition switch OFF, ground the SCS line with the HDS to take the PCM out of
active status, disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
NOTE: The SRS memory of codes is not cleared even if the ignition switch is turned OFF or the battery cables are disconnected from the battery.
-
Use replacement parts which are manufactured to the same standards and quality as the original parts. Do not install used SRS parts. Use only new
parts when making SRS repairs.
-
Carefully inspect any SRS part before you install it. Do not install any part that shows signs of being dropped or improperly handled, such as
dents, cracks or deformation.
-
Before removing any SRS parts (including disconnection of connectors), always disconnect the SRS connector.
-
Use only a digital multimeter to check the system. If it is not a Honda multimeter, make sure its output is 10 mA (0.01 A) or less when switched to
the lowest value in the ohmmeter range. A tester with a higher output could cause accidental deployment and possible injury.
-
Do not put objects on the front passenger's airbag.
-
The original audio system has a coded theft protection circuit. Make sure you have the anti-theft codes for the audio system and navigation system
(if equipped), then write down the audio presets before disconnecting the negative cable from the battery.
-
Before returning the vehicle to the customer, enter the anti-theft codes for the audio system and navigation system (if equipped), then enter the
audio presets; set the clock.
-
After disconnecting the negative cable from the battery, do the power window control unit reset procedure.
Steering-related Precautions
Cable Reel Alignment
-
Misalignment of the cable reel could cause an open in the wiring, making the SRS system, and the horn inoperative. Center the cable reel
whenever the following is performed.
-
Installation of the steering wheel
-
Installation of the cable reel
-
Installation of the steering column
-
Other steering-related adjustment or installation
-
Do not disassemble the cable reel.
-
Do not apply grease to the cable reel.
-
If the cable reel shows any signs of damage, replace it with a new one. For example, if it does not rotate smoothly, replace the cable reel.
Airbag Handling and Storage
Do not disassemble an airbag. It has no serviceable parts. Once an airbag has been deployed, it cannot be repaired or reused.
For temporary storage of an airbag during service, observe the following precautions.
-
Store the removed airbag with the pad surface up. Never put anything on the airbag.