Pilot 4WD V6-3.5L (2008)
17. Push the locknut against the transmission housing to seat the transmission range switch into the control shaft, and tighten the locknut (A) to 12 Nm
(1.2 kgf-m, 8.7 lbf-ft) while holding the control shaft (B) with a 6.0 mm wrench (C), then bend the lock tabs (D) of the lock washer against the
locknut.
18. Tighten the bolts (E) to 12 Nm (1.2 kgf-m, 8.7 lbf-ft) securing the transmission range switch.
19. Install the control lever (A), spring washer (B), lock washer (C), and locknut (D) on the control shaft (E).
20. Tighten the locknut to the specified torque, then bend the lock tab of the lock washer against the locknut.
21. Check the connectors for rust, dirt, or oil, clean, then connect the connector securely.
22. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the control lever, then insert the control
pin into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
23. Secure the shift cable bracket with the nuts.
24. Install the battery base bracket and battery base.
25. Install the intake air duct and the intake manifold cover.
26. Install the battery tray, battery, and battery hold down bracket, then connect the battery terminals.