Pilot 4WD V6-3.5L (2008)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
NOTE:
-
Removal of the front impact sensor must be performed according to precautions and procedures.
-
Before disconnecting the front impact sensor 2P connector(s), disconnect the driver's and front passenger's airbag 4P connectors, and both seat belt
tensioner 2P connector(s).
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while removing the front impact sensor.
1. Remove the battery, and wait at least 3 minutes before beginning work.
2. Remove the front bumper.
3. Remove the resonator, and washer reservoir.
4. Remove the tow hook brackets (A).
5. Disconnect the front impact sensor 2P connector (A) from the front impact sensor (B).
6. Using a TORX T30 bit, remove the TORX bolt (C), then remove the front impact sensor.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfering with other parts.
-
Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the front impact sensor.
1. Install the new front impact sensor with new TORX bolts (A), then connect the front impact sensor 2P connector (B) to the front impact sensor
(C).