Pilot 4WD V6-3.5L (2008)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test
1. Make sure you have anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, and remove the battery and battery tray.
4. Remove the intake manifold cover and the intake air duct.
5. Remove the battery base.
6. Disconnect the transmission range switch connector.
7. Check for continuity between terminals at the transmission range switch connector. There should be continuity between the terminals in the
following table for each transmission range switch position.
8. Transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that the transmission
range switch installation. If the transmission range switch installation is OK, replace the transmission range switch.