Pilot 4WD V6-3.5L (2008)
Starter Motor: Removal and Replacement
Starter Removal and Installation
REMOVAL
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the battery.
4. Remove the automatic transmission fluid (ATF) dipstick.
5. Remove the harness clamp (A).
6. Disconnect the starter cable (B) from the B terminal and BLK wire (C) from the solenoid S terminal.
7. Remove the two bolts holding the starter.
INSTALLATION
1. Install the starter (A) using a new gasket (B), then install the harness clamp (C), and connect the starter cable (D) to the B terminal and BLK wire
(E) to the solenoid S terminal. Make sure the crimped side of the ring terminal faces away from the starter when you connect it.
2. Install the ATF dipstick.
3. Connect the positive cable to the battery first, then connect the negative cable.
4. Start the engine to make sure the starter works properly.
5. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets.
6. Do the power window control unit reset procedure.
7. Set the clock (on vehicles without navigation).