Pilot 4WD V6-3.5L (2008)
2. Install the spring (E), and upper spring seat (F). Align the bottom of the spring and the lower spring seat (G) with lower arm B as shown.
3. Place a floor jack at the connecting point of lower arm B and the knuckle.
4. Raise the jack slowly until you can align the bolt holes of lower arm B and the knuckle, then loosely install the new flange bolt (A).
5. Raise the rear suspension with a floor jack to load it with the vehicle's weight.
6. Tighten the flange bolt and self-locking nut on the adjusting bolt to the specified torque values.
7. Install the wheel sensor harness (C).
8. Connect the stabilizer link to the lower arm B, then tighten the new flange nut (A) to the specified torque value while holding the joint pin (B) with
a hex wrench (C).
9. Install the rear wheel.
10. Check the rear wheel alignment, and adjust it if necessary.
^
First install all the components, and lightly tighten the bolts and nuts, then raise the suspension to load it with the vehicle's weight before fully
tightening to the specified torque values.
^
Align the cam positions of the adjusting bolt and the adjusting cam plate with the marked positions when tightening.
^
Before installing the wheel, clean the mating surfaces of the brake disc/drum and the inside of the wheel.