Pilot 4WD V6-3.5L (2008)
16. Place a floor jack under lower arm B. Remove the self-locking nut (A), washer, and flange bolt (C).
NOTE: During installation, install new flange bolt, and new self-locking nut.
17. For 4WD: Remove the knuckle while pushing in the driveshaft and holding the driveshaft outboard joint.
NOTE: Do not pull the driveshaft end outward. The driveshaft inboard joint may come apart.
18. Separate the hub (A) from the knuckle (B) using the hub dis/assembly tool and a hydraulic press. Hold the knuckle with the attachment (C) of the
hydraulic press or equivalent tool. Be careful not to deform the backing plate (D). Hold onto the hub to keep it from failing when pressed clear.
19. Remove the flange nuts (A), backing plate (B), and snap ring (C).