Pilot 4WD V6-3.5L (2008)
-1 Loosely install the new damper pinch bolts (A) and new flange nuts (B) to the damper (C).
-2 Install the wheel sensor harness (D) to the damper.
-3 Install the brake hose bracket (E) to the damper.
-4 Loosely install the stabilizer link (F) to the damper.
3. Raise the front suspension with a floor jack to load the suspension with the vehicle's weight.
4. Tighten the damper pinch bolts holding the flange nut to the specified torque value.
5. Tighten the flange nuts on top of the damper to the specified torque value.
6. Install the service caps.
7. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the front wheel.
8. Check the front wheel alignment, and adjust it if necessary.
Rear Suspension
Spring/Bump Stop Replacement
Spring/Bump Stop