Pilot 4WD V6-3.5L (2008)
![background image](/honda/pilot_4wd/v6-3.5l/Page-1897001.png)
Suspension Strut / Shock Absorber: Removal and Replacement
Front Suspension
Damper/Spring Removal and Installation
Removal
1. Raise the vehicle, and support it with safety stands in the proper locations.
2. Remove the front wheel.
3. Remove the damper.
-1 Remove the wheel sensor harness (A) from the damper (B). Do not disconnect the wheel sensor connector.
-2 Remove the brake hose bracket (C) from the damper.
-3 Disconnect the stabilizer link (D) from the damper.
-4 Remove the flange nuts (E) and damper pinch bolts (F) from the damper.
4. Remove the service caps (A), and remove the damper by removing the three flange nuts (B).
NOTE: Damper springs are different, left and right. Mark the springs L and R before you continue.
Installation
1. Loosely install the damper (A) onto the frame, then loosely install three new flange nuts (B).
2. Install the damper onto the knuckle.