Pilot 4WD V6-3.5L (2008)
5. Raise the rear suspension with a floor jack to load it with the vehicle's weight.
6. Tighten the flange bolt to the specified torque value.
7. Install the wheel sensor harness (C).
8. Connect the stabilizer link to the lower arm B, then tighten the new flange nut (A) to the specified torque value while holding the joint pin (B) with
a hex wrench (C).
9. Clean the mating surfaces of the brake disc/drum and the inside of the wheel, then install the rear wheel.
10. Check the rear wheel alignment, and adjust it if necessary.