Pilot 4WD V6-3.5L (2008)
20. Press the wheel bearing (A) out of the knuckle (B) using the attachment, the driver and a press.
21. Press the wheel bearing inner race (A) from the hub (B) using the hub dis/assembly tool, commercially available bearing separator (C), and a
press.
22. Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
23. Press a new wheel bearing (A) into the knuckle (B) using the old bearing (C), a steel plate (D), the support base, and a press. Be careful not to
damage the sleeve of the pack seal.
24. Install the snap ring (A), backing plate (B), and flange nuts (C). Tighten the flange nuts to the specified torque.