Pilot 4WD V6-3.5L (2008)
13. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
14. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
15. Install A/T clutch pressure control solenoid valves A and B.
16. Install the harness cover on the cover bracket, and secure it with the bolt.
17. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely. Install the harness clamp on the
bracket.
18. Apply molybdenum grease to the hole in the bushing in the cable end. Attach the shift cable end to the control lever, then insert the control pin into
the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
19. Secure the shift cable bracket with the nuts.
20. Install the battery base bracket and battery base.
21. Install the intake air duct and the intake manifold cover.
22. Install the battery tray, battery, and battery hold down bracket, then connect the battery terminals.
23. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets. Set the clock (on vehicles
without navigation).
24. Do the power window control unit reset procedure.