Pilot 4WD V6-3.5L (2008)
6. Exit the HDS, then select the CM Update, and follow the screen prompts to update the PCM.
7. If the software in the PCM is the latest, disconnect the HDS/HIM from the DLC, and go back to the procedure that you were doing. If the software
in the PCM is not the latest, follow the instructions on the screen. If prompted to select the PGM+I system or the A/T system, make sure you
update both.
NOTE: If the PCM update system requires you to cool the PCM, follow the instructions on screen. If you run into a problem during the update
procedure, (programming takes over 15 minutes, status bar goes over 100%, D or immobilizer light flashes, HDS tablet freezes, etc.), follow these
steps to minimize the chance of damaging the PCM:
^
Leave the ignition switch in the ON (II) position.
^
Connect a jumper battery (do not connect a battery charger).
^
Shut down the HDS.
^
Disconnect the HDS from the DLC.
^
Reboot the HDS.
^
Reconnect the HDS to the DLC, and try the update procedure again.
8. If the TP POSITION CHECK failed in step 6, clean the throttle body.
9. Do the PCM idle learn procedure.
10. Do the crank (CKP) pattern learn procedure.