Pilot 4WD V6-3.5L (2008)
Transmission Speed Sensor: Service and Repair
Input Shaft (Mainshaft) Speed Sensor Replacement
Input Shaft (Mainshaft) Speed Sensor Replacement
1. Remove the splash shield.
2. Disconnect the input shaft (mainshaft) speed sensor connector, and remove the input shaft (mainshaft) speed sensor (A).
3. Install the new O-ring (B) on the new input shaft (mainshaft) speed sensor and apply clean ATF to the O-ring, then install the input shaft
(mainshaft) speed sensor in the transmission housing.
4. Check the connector for rust, dirt, or oil, then connect the connector securely.
5. Install the splash shield.