Pilot 4WD V6-3.5L (2008)
24. Install new O-rings (two O-rings per solenoid valve) (E) on each reused solenoid valves.
NOTE: A new solenoid valve comes with new O-rings. If you install a new solenoid valve, use the O-rings provided on it.
25. Install shift solenoid valve B (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
NOTE: Do not hold the solenoid valve connector to install the solenoid valve. Be sure to hold the solenoid valve body.
26. Install torque converter clutch solenoid valve (D) (black connector) by holding the solenoid valve body; make sure the mounting bracket contacts
the accumulator body.
27. Install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the bracket of
torque converter clutch solenoid valve.
NOTE: Do not install shift solenoid valve C before installing torque converter clutch solenoid valve. If shift solenoid valve C is installed before
installing torque converter clutch solenoid valve, it may damage to hydraulic control system.
28. Install shift solenoid valve A (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the
accumulator body.
29. Connect the harness terminals to the solenoids:
^
RED wire connector to shift solenoid valve A.
^
ORN wire connector to shift solenoid valve B.
^
GRN wire connector to shift solenoid valve C.
^
YEL wire connector to the torque converter clutch solenoid valve.
30. Install the shift solenoid valve cover, dowel pins, and a new gasket.
31. Install the new solenoid valve body gasket on the solenoid valve cover, and install the ATF pipes with the filter end in the transmission housing.
Install new O-rings over the ATF pipes.
32. Install A/T clutch pressure control solenoid valves A and B.
33. Install the harness cover on the cover bracket, and secure it with the bolt.
34. Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely. Install the harness clamp on the
bracket.
35. Apply molybdenum grease to the hole in the bushing in the cable end. Attach the shift cable end to the control lever, then ,insert the control pin
into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
36. Secure the shift cable bracket with the nuts.
37. Install the battery base bracket and battery base.
38. Install the intake air duct and the intake manifold cover.
39. Install the battery tray, battery, and battery hold down bracket, then connect the battery terminals.
40. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets. Set the clock (on vehicles
without navigation).
41. Do the power window control unit reset procedure.