Pilot 4WD V6-3.5L (2008)
7. Install the No. 2 propeller shaft protector (A).
8. Install the No. 1 propeller shaft protector (A).
9. If you installed a new propeller shaft, test-drive the vehicle at 55 mph (88 kph), and check for noise or vibration.
^
If there is no noise or vibration, the repair is complete.
^
If there is a noise or vibration, go to step 10.
10. Remove the mounting bolts from the propeller shaft at the rear differential companion flange. Note the current alignment of the propeller shaft to
the rear differential companion flange.
11. Rotate the propeller shaft 180 degrees from its current alignment with the rear differential companion flange.
12. Install new mounting bolts and tighten them to the specified torque, go to step 4.