Pilot 4WD V6-3.5L (2008)
6. Install the outboard joint (A) into the front wheel hub (B).
7. Install the knuckle (A) onto the lower arm (B). Be careful not to damage the ball joint boot (C). Wipe off the grease before tightening the nut at the
ball joint. Torque the new castle nut (D) to the lower range of torque specification, then tighten it only far enough to align the slot with the pin
hole. Do not align the nut by loosening.
NOTE: Make sure the ball joint boot is not damaged or cracked.
8. Install the new lock pin (E) into the pin hole as shown.
9. Connect the front stabilizer link to the damper.
10. Apply a small amount of engine oil to the seating surface of the new spindle nut (A).