Pilot 4WD V6-3.5L (2008)
Axle Shaft Assembly: Overhaul
Front Driveshaft Disassembly
Front Driveshaft Disassembly
Special Tools Required
^
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
^
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint (B) (left driveshaft).
2. Remove the boot bands. Be careful not to damage the boot.
^
If the boot band is a locking tab type (A), pry up the locking tab (B) with a screwdriver, and lift up the end of the band.
^
If the boot band is a double loop type (C), lift up the band end (D), and push it into the clip (E).
^
If the boot band is a low profile type (E), pinch the boot band using commercially available boot band pliers (F).