Pilot 4WD V6-3.5L (2008)
13. Remove the inboard boot and boot band (B). Be careful not to damage the boot.
14. Remove the vinyl tape.
Outboard Joint Side
1. Remove the boot bands (A). Lift up the three tabs (B) with a screwdriver. Be careful not to damage the boot.
2. Slide the outboard boot (A) partially to the inboard joint side. Be careful not to damage the boot.
3. Wipe off the grease to expose the driveshaft and the outboard joint inner race.
4. Make a mark (A) on the driveshaft (B) at the same level as the outboard joint rim (C).