Pilot 4WD V6-3.5L (2008)
25. Bend the band end (A) by tapping it down with a hammer.
NOTE:
^
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
^
Remove any grease remaining on the surrounding surfaces.
26. Repeat steps 18 through 25 for the band on the other end of the boot.
27. Install a new locking tab type boot band on the inboard joint side of the inboard boot. Fold down the locking tabs.
28. Lightly tap on the doubled-over portions to reduce their height.
29. Repeat steps 27 through 28 for the band on the other end of the boot.
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent damaging the outboard boot.