Pilot 4WD V6-3.5L (2008)
6. To completely seat the outboard joint, pick up the driveshaft and joint, and tap or hit them from a height of about 10 cm (4 in.) onto a hard surface.
NOTE: Do not use a hammer as excessive force may damage the driveshaft. Be careful not to damage the threaded section (A) of the outboard
joint.
7. Check the alignment of the paint mark (A) you made with the outboard joint rim (B).
8. Pack the outboard joint (A) with the remaining joint grease included in the new outboard boot set.