Pilot 4WD V6-3.5L (2008)
^
Do not pull the driveshaft end outward. The driveshaft inboard joint may come apart.
^
During installation, apply grease to the mating surfaces of the wheel bearing and driveshaft outboard joint.
15. Separate the hub (A) from the knuckle (B) using the hub dis/assembly tool and a hydraulic press. Hold the knuckle with the attachment (C) of the
hydraulic press or equivalent tool. Be careful not to deform the splash guard (D). Hold onto the hub to keep it from falling when pressed clear.
16. Remove the snap ring (A) and the splash guard (B) from the knuckle (C).
17. Press the wheel bearing (A) out of the knuckle (B) using the attachment, the driver, and a press.
18. Press the wheel bearing inner race (A) from the hub (B) using the hub dis/assembly tool, commercially available bearing separator (C), and a
press.