Pilot 4WD V6-3.5L (2008)
14. Attach the molding upper seal (A) and molding side seal (B) to the inside surface of the molding (C) with adhesive tape as shown:
-
Be sure the molding upper seal and molding side seal line up with the alignment dots (D).
-
Be careful not to touch the windshield where adhesive will be applied.
15. Install the clips to the body.
16. Set the windshield in the opening, and center it. Make alignment marks (A) across the windshield and body with a grease pencil at the four points
shown. Be careful not to touch the windshield where adhesive will be applied.
17. Remove the windshield.